DataCard 150i Owner's Manual page 28

Error Error
Message Code
(LCD) (LCD)
Embossing XXYY0D
Error
XXYY0E
XXYY0F
XXYY10
XXYY12
XXYY13
XXYY14
Coordinate XXYY15
Out Of Range
Command out XXYY16
of sequence
Card Supply XXYY17
Empty
Card Feed XXYY18
Error
Card Feed XXYY19
Error
None XXYY1A
None
XXYY1B
None
XXYY1C
22
Possible
Meaning
Cause
The upper or Two cards in
lower emboss card carriage
mechanism did
not find home
as expected.
Excessive
variation in the
card stiffness
or thickness
Data exceeds Too many
physical limits emboss
of the card characters on
the card or
invalid
embossing
location
specified.
Sensors in the Interlock
system did not circuit opened
transition in the while picking
expected card.
sequence.
Card supply No cards
loaded
sensor did not
transition as
expected. Card weight
not installed
Card Picked No cards in
sensor did not input hopper,
become card weight
blocked as installed
expected. backwards.
Cards stuck
together
Card weight
not installed
Card Picked Too many
Sensor single cards
remained inserted.
blocked after
transport
Card weight
attempted to
not installed
pick card.
Requested None
motor is on.
User requested None
motor stop.
Illegal wheel Flash memory
position failure
requested.
Corrective Action
(Operator)
Remove cards from carriage or any
loose cards in system. Try sending
the card data again.
Remove cards from carriage or any
loose cards in system. Reinitialize
the system. Try sending the card
data again.
Send the same card data again. Try
sending a different customer record.
Ensure that the cover is closed
properly and that the interlock
switch bracket is not bent.
Load cards
Install weight.
Remove and reload cards. Install
card weight correctly.
Fan cards before loading to remove
static. Reload cards.
Remove and reload cards. Install
weight.
Remove all cards from the input
hopper and remove any jammed or
protruding cards. Reinitialize the
system.
Install weight.
None
None
Reinitialize system
Status Code Card
Sent to Processing
Application Status
D = Wheel Card moved to
Stepper Error reject tray
R = Embossing No card
limits exceeded processed
M = Interlock Card processing
open stops
Z = Input hopper No card
empty processed
G = Card Feed Card in input
Error hopper or
magnetic stripe
module
G = Card Feed Card in Input
Error hopper or
magnetic stripe
module
P = System Error No card
processed
Owner's Manual