Check Fluid Levels; Check Engine Oil Level; Check Hydraulic Oil Level; Check Tire Pressure - Snapper ZTR 800X Series Dealer Setup & Adjustment Instructions Manual

Check Fluid Levels

Check Engine Oil Level

1. Raise the hood to gain access to the engine oil dipstick.
2. Use the engine oil dipstick (A, Figure 11) to check the
engine oil level. If necessary add engine oil through the
crankcase oil fill (B). Check the engine manufacturer's
owner's manual for oil recommendations.

Check Hydraulic Oil Level

1. Raise the hood to gain access to the hydraulic oil
reservoir.
2. Before removing the reservoir cap, make sure the area
around the reservoir cap and the fill neck of the reservoir
is free of dust, dirt, or other debris.
3. Unscrew the reservoir cap (B, Figure 12).
4. Look down the filler neck of the hydraulic oil reservoir
(A) and observe the oil level. When cold, the oil level
should be approximately 4" (10 cm) below the top of the
filler neck.
5. If necessary, add either Mobil 1™, 15W-50 synthetic oil
or Castrol Syntec™ 5W-50 oil. DO NOT use conventional
oils.
6. Reinstall the reservoir cap.
Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life.
Tire
Deck Caster Tires
Drive Tires
Tractor Caster Tires
800X Series Zero-Turn Rider - 61" & 72" Mower Deck
Figure 11. Check Engine Oil Level (Unit Shown With Hood
Raised)
A. Engine Oil Dipstick
B. Crankcase Oil Fill
Figure 12. Checking Hydraulic Oil Level
A. Hydraulic Oil Reservoir
B. Reservoir Cap
Pressure
Figure 13. Checking Tire Pressure
25 psi (1,03 bar)
10 psi (0,69 bar)
25 psi (1,03 bar)
B
A
B
A
7