Check Fluid Levels; Check Engine Oil Level; Check Hydraulic Oil Level; Check Tire Pressure - Snapper S150X-21HP Dealer Setup & Adjustment Instructions Manual

Check
Fluid Levels
Check the Engine Oil Level
1. Use the dipstick (A, Figure 11) to check the engine
oil level. If necessary add engine oil. Check the
engine manufacturer's owner's manual for the oil
recommendations.
Check the Hydraulic Oil Level
NOTE: Do not open the hydraulic reservoir unless oil is
being added.
1. Before removing the reservoir cap, make sure the
area around the reservoir cap and fill neck of the
reservoir is free of dust, dirt, or other debris.
2. Unscrew the reservoir cap (B, Figure 12).
3. Look down the filler neck of the hydraulic oil reservoir
(A) and observe the oil level. When cold, the oil level
should be approximately 4" (10 cm) below top of the
filler neck.
4. If necessary, add SAE 20W-50 motor oil.
5. Reinstall the reservoir cap.
Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that
these pressures may differ slightly from the "Max
Inflation" stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve the
cut quality, and extend the tire life.
Tire
Front
Rear
10/2007
S150X 21HP, 23HP, 25HP & 27HP - 48" & 52" Mower Deck
Pressure
25 psi (1,72 bar)
15 psi (1,03 bar)
Figure 11. Pre-start Checks
A. Crankcase Oil Fill
Figure 12. Checking the Hydraulic Oil Level
A. Hydraulic Oil Reservoir
B. Reservoir Cap
Figure 13. Checking Tire Pressure
7
A
B
A
TP 300-7343-A-M1-SP