Advertisement
16
17
18
19
20
Step 16: Reattach the pull cord side cover. Start by
guiding the top right of the panel around the groove under
gas cap. The back side of the rubber fuel collector has a
plug that needs to be guided into place before the sides
are reconnected.
Step 17: Screw in the Phillips screw at the front right of
the case to help reattach the clip that was removed in
step 5.
Step 18: Using a flat head screw driver reattach the clip
under the rubber fuel collector that was removed in step 5.
Step 19: Screw in the 2 Phillips screws removed in step 1
from the top of the generator on the pull cord side.
Step 20: Reinstall the muffler grate by tilting the bottom in
first so that the tab lines up. Push in the top two tabs so
that the panel is flush. Then screw in the 6 Phillips screws
removed in step 2 that hold the muffler grate in place.
Advertisement
