Assembly On Arrival; Bike Bag; Scope Of Delivery; Mounting The Wheels To The Base Tray Of The Bike Bag - Bowers & Wilkins 96002 Manual

B&W bike box
BicyclE usEr maNual
OpEratiNg iNstructiONs EN 14766
Read pages Perform the functional Observe the
6 and 7 before check on pages 8 and 9 bike card on
your first ride! before every ride! the rear
mtB/crOss
Full-suspENsiON
Hardtail
26
2.1
Place the packed wheels in the B&W bike
case, the sprocket pointing inwards in the
frame triangle section where it cannot
cause any damage. Close the case while
it is lying on the ground and make sure
that nothing gets caught. Pressure must
not have to be applied; otherwise you will
have to move the freight around slightly.
Close the locks.
2.2
Place the case upright and tie the lashing
strap around the bike box. This means that
if the locks fail, the B&W lashing strap still
holds the freight together.
2.3
Insert your business card or a note with
your address in the little address pocket.
Please note that a bike case weighing
i
more than 30 kg may not be transported
by the airline. Inform yourself in good time
before departure.

Assembly on arrival

Assemble the bike in the reverse order to dis-
mantling.
2.4
Read the information in your general bike
instruction manual on setting the relevant
components and especially the informa-
tion on correct fixing of components
(screw torque).
cover!!
Perform the "before each ride" check after
g
assembly.
This manual cannot teach you the skills of
g
bicycle mechanic or fitter. If you are uncer-
tain, please contact a local bike retailer or
a training workshop.
EN

3. bike bag

3.1
Scope of
delivery
1. ASF frame
2. Rear mount
3. Front mount
4. Extension
5. ASF screws
6. Adapter for rear
†
quick-releases
7. Adapter for front

quick-releases
8. Wheels with supports
9. Fixing parts for
wheel supports
10. bike bag
3.2
Should you require adapters for
i
the full-floating axle system of your
mountain bike, please contact us
at info@b-w-international.com or
+49-(0)5451/8946-0.
Mounting the wheels to the
base tray of the bike bag
3.3
Place the wheel with the support on the
base tray. Fix the wheel from inside with
two screws measuring 4.2 x 16. Please
note that the silver washers are generally
used from the inside.
3.4
Screw the wheel support with two screws
measuring M 4 x 14 mm von from the
outside onto the face end of the base tray.
Fix the support with an additional M4 x 20
mm screw on the side. Make sure that the
black washers/spacers are generally used
on the outside.
Fix the second wheel in the same way.
Š
…
‚ ƒ
…
‡
„
ˆ
‰
B&W
27