Quick Setup Guide Welcome Congratulations on purchasing your AudioCodes Mediant 1000B Gateway and Enterprise Session Border Controller (E-SBC), hereafter referred to as the device! This document is intended to provide basic setup instructions for initial access to the device and for connecting it to your network.
Page 2
Physical Description of Front Panel [The number and type of port interfaces depend on your ordered hardware configuration.] FXS, FXO, BRI, Telephony port interfaces and DSP resources, which can include any one or a TRUNKS, & combination of FXS (RJ-11), FXO (RJ-11), ISDN BRI (RJ-45), ISDN PRI (RJ-48), and Media Processing Module (MPM) interfaces.
Page 3
CRMX CRMX module, providing RS-232 serial interface port (flat connector). Dry-contact relay connector for interfacing with a third-party, external alarm system (separate orderable item). Reset pinhole button for resetting the device or restoring it to factory defaults (press and hold down the button for at least 12 seconds, but no more than 25 seconds).
Mounting the Device You can mount the device on a desktop using the four anti-slide bumpers (supplied), which you need to stick on the grooves located on the underside of the device. Alternatively, you can mount the device in a standard 19-inch rack, using one of the following methods: Attaching the device to the rack posts using the pre-attached front-mounting brackets.
Page 5
Assigning an IP Address to the Device Use the device's factory default IP address (192.168.0.2/24 and Default Gateway 0.0.0.0) to initially access the device's Web-based management interface and then change it to suit your networking addressing scheme for subsequent connectivity. Using a CAT-5e/6 straight-through RJ-45 Ethernet cable, connect the device's Ethernet port GE 0/1 or 0/2 (front panel) to the LAN port of your computer.
Page 6
Select the OAMP interface ('Application Type' with OAMP + Media + Control), click Edit, and then in the dialog box, modify the device's OAMP interface. Click Apply to submit your changes; your connection with the device becomes unavailable at the default IP address (due to the new IP address).
Safety Precautions This device is an indoor unit and therefore, must not be installed outdoors. Ethernet cabling must be routed only indoors and must not exit the building. The device must be installed and serviced only by qualified service personnel. ...
Page 8
About AudioCodes AudioCodes Ltd. (NasdaqGS: AUDC) is a leading vendor of advanced voice networking and media processing solutions for the digital workplace. With a commitment to the human voice deeply embedded in its DNA, AudioCodes enables enterprises and service providers to build and operate all-IP voice networks for unified communications, contact centers and hosted business services.