Related Manuals for Soleus Air SG-CAC-08ESE
Summary of Contents for Soleus Air SG-CAC-08ESE
- Page 1 Model SG-CAC-08ESE SG-CAC-10SE SG-CAC-12SE Electronic Casement Window Air Conditioner Operating Instructions...
-
Page 2: Important Safety Instructions
Thank you for choosing a Soleus Air powered by Gree Air Conditioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new air conditioner. -
Page 3: Specifications
Rated Current Cooling (Amperage) Cooling EER Noise Level dB(A) (High/Med/Low) CFM (High/Med/Low) Power Plug Type Product Dimensions (W” x D” x H” ) (Inches) Product Weight (Lbs) Refrigerant Energy Star SG-CAC-08ESE SG-CAC-10SE 1/115/60 1/115/60 31.2 8,000 10,000 1052 10.5 56/54/52... -
Page 4: Meeting Electrical Requirements
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this air conditioner These instructions describe installation in a typical wood framed window with a wood SLIDE-BY sash, or installation in a metal CASEMENT window. Modification may be necessary when installing in windows made differently than those shown in these instructions. -
Page 5: Preparing For Installation
PREPARING FOR INSTALLATION PREPARING FOR INSTALLATION Installation Tips For wood-frame casement windows: It may be necessary to construct a frame, using at least 1-inch thick wood, with a 15-1/2-inch wide opening. For brick or cement building construction: It may be necessary to put a wood stool strip under AC, for mounting pur- poses. - Page 6 PARTS LIST & INSTALLATION...
-
Page 7: Installation
CAUTION Property Damage Hazard—Failure to adhere to the following precautions could result in damage to window or the air conditioner. Make sure the wood stool or window track is securely attached to the building construction. Use longer screws in sub-framing if necessary. - Page 8 INSTALLATION—SLIDING INSTALLING THE UNIT IN A SLIDING WINDOW (CONT.) Peel off protective backing from track seal. Apply seal to room side of window track. Center of seal strip should coincide with the line marked in Step 2. The two screw holes drilled in Step 3 should be directly above seal strip in the inner track.
- Page 9 INSTALLATION—SLIDING INSTALLING THE UNIT IN A SLIDING WINDOW (CONT.) 10. Clamp plastic window panel between a board and a work table, and cut along cutting line with a fine tooth saw. Remove any burrs with a file. 11. Fasten side channels to the sides of the AC using 3 screws (Item 17) per channel.
- Page 10 Use a #8-32x3/4-inch self-threading screw. NOTE: The bracket prevents movement of the air conditioner (either in or out) after completing the installation. 18. Stuff the foam seal strip/sash seal between the vertical sash and the window glass, as shown right.
- Page 11 INSTALLATION—CASEMENT INSTALLING THE UNIT IN A CASEMENT WINDOW NOTE: Open the window the maximum amount to allow for clearance of the cabinet. The crank handle should be removed to allow the platform to be fastened to the jamb. If the window cannot open far enough (more than 15-1/2 inches) for the cabinet to clear the window, remove the window entirely by drilling out the rivets.
- Page 12 INSTALLATION—CASEMENT INSTALLING THE UNIT IN A CASEMENT WINDOW (CONT.) 5. Adjust the platform assembly so that the rear of the air conditioner will be 3/16-inch lower than the front. This ensures proper water drainage from the air conditioner. NOTE: A projection below the base of the air...
- Page 13 NOTE: DO NOT push or pull the air direction louvers. 13. Place the air conditioner in the window opening as shown to the right. It should sit on the platform assembly so that the window panel frame, and the cabinet side channels are against the top and side window jambs.
-
Page 14: For Your Safety
• If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass prior to installation. If the windows is a triple-track type with a screen panel included, remove the screen completely before installation. -
Page 15: Operation Of Current Device
• The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or it cannot be reset. A new one can be obtained from Soleus Air Powered by Gree. • If the power supply cord is damaged, it CANNOT be repaired. It MUST be replaced with one obtained from Soleus Air Powered by Gree. -
Page 16: Operating Your Air Conditioner
OPERATING YOUR AIR CONDITIONER Before you start using your air conditioner, please familiarize yourself with the control panel and remote control functions. This air conditioner can be controlled by the control panel (touch pad) or the included remote control. CONTROL PANEL (TOUCH PAD) 1) Power On and Off - Press the POWER to turn the unit ON and OFF. -
Page 17: Remote Control
Take the remote control with you so the air conditioner cools the room to your loca- tion. SLEEP MODE - Press the SLEEP button to turn SLEEP mode on or off. - Page 18 OPERATING YOUR AIR CONDITIONER REMOTE CONTROL 9. LOCK/UNLOCK- Press the “+” and “—” buttons simultaneously to lock and unlock the remote control. When the remote is locked, none of the functions or setting can be changed using the remote. 10. F° or C° - To switch between the F° or C° settings, press the MODE and “—” buttons a the same time.
-
Page 19: Air Conditioner Features
EXHAUST CONTROL The Exhaust control allows the air conditioner to recirculate inside air when it is set to CLOSED. When it is set to OPEN the air conditioner exhaust air outside and brings in fresh air. Use the CLOSED position when maximum cooling is needed. -
Page 20: Care And Cleaning
Winter Storage To store the air conditioner when it is not in use for an extended period of time, remove it care- fully from the window according to the installation instructions and cover it with plastic or place it in the original box. -
Page 21: Troubleshooting
TROUBLESHOOTING PROBLEM The Air Conditioner will not start The Air Conditioner does not cool as it should The Air Conditioner is freezing up The Remote Control is not working POSSIBLE CAUSES The air conditioner is unplugged The fuse is blown/circuit breaker is tripped. - Page 22 “HS” The Air Conditioner Display reads “ES” POSSIBLE CAUSES Hot and Humid weather. The air conditioner is not correctly tilted outside. Moisture removed from the air is draining into the base pan. A Sensor has failed in the air conditioner...
-
Page 23: Warranty
One Year Limited Warranty Soleus International, Inc. warrants the accompanying Soleus Air Powered by Gree Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States.