MSI 880G-E45 Series Manual page 26

MS-7576 Mainboard
Fan Power Connectors: CPUFAN1, SYSFAN1~3
The fan power connectors support system cooling fan with +12V. When connecting the
wire to the connectors, always note that the red wire is the positive and should be con-
nected to the +12V; the black wire is Ground and should be connected to GND. If the
mainboard has a System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take advantage of the CPU fan control.
CPUFAN1
Important
Please refer to the recommended CPU fans at processor's official website or consult
•
the vendors for proper CPU cooling fan.
• CPUFAN1 supports fan control. You can install Overclocking Center utility that will
automatically control the CPU fan speed according to the actual CPU temperature.
• Fan cooler set with 3 or 4 pins power connector are both available for CPUFAN1.
S/PDIF-Out Connector: JSP1
This connector is used to connect S/PDIF (Sony & Philips Digital Interconnect Format)
interface for digital audio transmission.
S/PDIF-Out Bracket (optional)
En-16
SYSFAN1~2
* The MB layout in this figure is for reference only.
SYSFAN3