Cem40 Cable Management - iOptron CEM40 Instruction Manual

2.4. CEM40 Cable Management

The CEM40 mount has a pre-wired Cable Management Panel (CMP) which provides a 12V 3A max.
power outlet and a USB 2.0 port. As shown in Figure 3, the Cable Management Panel has the following
connections:

1X USB 2.0 ports with standard type A connectors for connecting accessory

1X DC12V power outlet (2.1mmX5.5mm, center positive) for powering accessories such as
CCD cameras, filter wheels, or electric focusers

GUIDE: ST-4 compatible autoguiding port. The wiring is shown in Figure 4
The USB-A port on the Cable Management Panel are connected to the USB-B connector on Input
Panel, as shown in Figure 5.

1x USB 2.0 port with a standard type B connector

1X iPolar USB port for internal iPolar electronic polar scope connection
There is a hole on dovetail saddle that allows owners to run their own cables down through the mount,
either from the back of RA axle or bottom of the DEC axle.
Figure 3.Cable management panel
Figure 4. ST-4 Compatible Guiding Port Wiring
Figure 5. Input panel
8