Table of Contents
Advertisement
PROBLEM
1. Fuel tank empty.
Engine Will Not Start
Using Recoil Starter
2. Engine needs choking and priming.
3. Spark plug wire disconnected.
4. Fuel shut off valve closed.
Engine Will Not Start
1. Power extension cord not plugged into machine or
Using Electric Starter
2. Power extension cord damaged.
3. Starter switch damaged or faulty.
Engine Stalls or Stops 1. Water, debris or stale fuel in fuel system.
2. Choke control in the "CHOKE" position.
After Running
3. Fuel tank empty.
4. Air intake clogged with snow or debris.
5. Spark plug defective or gap set improperly.
1. Engine lubrication oil level is low.
Engine Loses Power
2. Spark plug faulty.
3. Water, debris or stale fuel in fuel system.
1. Damaged, out of balance or bent auger.
Excessive Vibration
2. Loose engine or auger/impeller components.
3. Bent or loose Idler pulley.
4. Cracked, severed or frayed belt.
Poor Snow
1. Clogged discharge chute.
2. Damaged or bent auger/impeller or components.
Discharging
3. Cracked, severed or frayed belt.
4. Belt tension out of adjustment.
5. Insufficient lubrication in auger bearings.
ITEM
SERVICE PERFORMED
Replace
Spark Plug
Engine Oil
Check Oil Level
Initial Oil Change
Periodic Oil Change
Air Filter
Clean or Replace
Clean Shroud & Fins
Engine Cooling
System
Drive Belts
Check For Adjustment,
Wear and Tension
Auger &
Check For Damage &
Lubrication
Impeller
Tires
Check Air Pressure
TROUBLESHOOTING
PROBABLE CAUSE
120 Volt outlet for U.S.A. or 230 Volt for Europe.
SERVICE SCHEDULE
Engine Manual
Engine Manual
Engine Manual
Engine Manual
Engine Manual
Engine Manual
Page 15-17
Page 13
Page 8
1. Fill fuel tank with fresh fuel/oil mix.
2. Move choke control to "CHOKE" position. Push
3. Place spark plug wire onto spark plug.
4. Move fuel shut off valve to the on position.
1. Plug power extension cord into machine & into 120
2. Discard damaged power extension cord.
3. Replace starter switch.
1. Drain and clean fuel system.
2. Move choke control to "OFF" position.
3. Fill with fuel to proper level.
4. Unclog air intake.
5. Service spark plug.
1. Add oil to the engine to full level.
2. Service spark plug.
3. Drain and clean fuel system.
1. Service auger.
2. Service and tighten loose components.
3. Tighten or replace pulley.
4. Replace belt.
1. Stop engine and unclog discharge chute.
2. Service auger/impeller or components.
3. Replace belt.
4. Adjust belt tension.
5. Lubricate all bearings as specified in manuals.
REF.
EACH
USE
HRS
X
X
X
21
CORRECTIVE ACTION
primer bulb three times.
Volt outlet for U.S.A. or 230 Volt for Europe.
5
25
50
HRS
HRS
X
X
X
X
100
EACH
HRS
SEASON
X
X
X
X
Hide quick links:
Advertisement
Table of Contents
