Troubleshooting, Adjustments, & Service; Troubleshooting - Snapper L1226E Operator's Manual

Troubleshooting, Adjustments, & Service

TROUBLESHOOTING

This section provides troubleshooting and service instruc-
tions. Locate the problem and check the possible cause/
remedy in the order listed.
Also, refer to the Engine Owner's Manual for additional
information.
For problems not covered here, contact your authorized
service dealer.
Problem
Engine fails to start.
Engine starts hard or runs poorly.
Scraper bar does not clean hard
surface.
Auger does not rotate.
Before performing any adjustment or service to
snowthrower, stop the engine and wait for mov-
ing parts to stop. Remove the key. To prevent
accidental starting, disconnect the spark plug
wire and fasten away from the plug.
Possible Cause
Key is OFF.
Failure to prime cold engine
Fuel valve is in CLOSED position.
Out of fuel.
Choke OFF - cold engine.
Engine flooded.
No spark.
Water in fuel, or old fuel.
Fuel mixture too rich.
Carburetor adjusted incorrectly.
Spark plug faulty, fouled, or gapped
improperly.
Fuel cap vent is blocked.
Skid shoes improperly adjusted.
Skid shoes improperly adjusted.
Auger control not engaged.
Foreign matter blocking auger.
Auger drive clutch cable slack.
Auger drive belt slipping.
Broken belt.
Shear pin broken.
28
WARNING
Push key in to the ON position.
Press primer button twice and
restart.
Turn valve to OPEN position.
Fill fuel tank.
Turn choke to ON, set throttle to
FAST.
Turn choke to OFF; try starting.
Gap plug, clean electrode,
or replace plug as necessary.
Drain tank. (Dispose of fuel at an
authorized hazardous waste facility.)
Fill with fresh fuel.
Move choke to OFF position.
See your authorized service dealer
for adjustments.
Clean and gap, or replace.
Clear vent.
RAISE skid shoes (this lowers the
scraper bar).
LOWER skid shoes (this raises the
scraper bar.)
Engage auger control.
STOP engine and REMOVE the
key. DISCONNECT the spark plug
wire. Clear auger using clean-
out tool. See warning in SAFETY
RULES.
Tighten to remove slack. See auger
clutch cable adjustment.
Check auger drive belt adjustment.
Replace belt.
Replace shear pin.
Remedy