Removal &
Normal Installation
A
Figure 25. Dozer Removal
A. Rotator Motor Plug
B. Lift Rod
Removal
1. Fully raise and support the snowthrower with wood
blocks.
2. Release the lift assist spring. Remove the spring and
spring bracket (E, Figure 25) from the tractor.
3. Lower the snowthrower.
4. Remove the clevis pin and clip (F) from the remote
deflector control and disconnect the control from the
mounting bracket.
B
C
C. Hair Pin Clip
D. Hitch Pin & Clip
E
D
E. Spring Bracket
F. Clevis Pin & Clip
5. Disconnect the rotator motor plug (A).
6. Disconnect the rear of the lift rod (B) from the lift arm
extension. Remove the hair pin clip (C) from the front
of the lift rod. Remove the lift rod. Remove the lift
arm extension from the tractor (see Hitch Installation
Instructions).
22
F