Table of Contents
Advertisement
Tray Installation
The following section will help you install the Sun StorageTek 6540 Array into a
customer-supplied cabinet.
Stack-up and Cabling
It is recommended that the trays are stacked in the cabinet exactly as they would
have been if shipped with the Sun Rack 1000-38, as stated in
"Cabinet Markings and
Tray Placement" on page
13. This will help you use the supplemental manuals that
show how the trays are arranged in the cabinet and how the drive interface cables
are connected from the controller tray to the expansion trays.
Refer to the Hardware Cabling Guide to see how to stack-up the trays and how to
route the FC cables. Refer to the Hardware Installation Guide for information about
applying power, adding expansion trays, and using a cabinet with a patch panel (or
cabling a two-cabinet configuration).
Controller Tray Check-up
The Sun StorageTek 6540 Array has various status indicators on the chassis. See
to help with the setup and to determine the status of the system once
FIGURE 3-1
power is applied. Refer to the Hardware Installation Guide for more information.
Controller Tray Status Indicators
FIGURE 3-1
28
Sun StorageTek 6540 Rack Ready Site Preparation and Installation Support Guide • July 2006
Advertisement
Table of Contents
