S Downloading A Ccp Msc-400 Project - Universal Remote Control MSC-400 Programming Manual

19 In MX/TX Editor, program the appropriate buttons for the RF Triggers for the Press & Hold Relay com-
mands or any other Relay commands to be tested from the remote. See Section: Programming
Macro Triggers to CCP Remotes on page 55 for additional information.
20 Save and Download the MX/TX project. See Section: Saving and Downloading a MX/TX Project.
21 Test from the remote by Pressing and Holding the appropriate buttons.
Saving And Downloading A MSC-400 Proejct
When all configuration and programming have been completed, the MSC-400 Project should be saved and
downloaded to the MSC-400.
1 To Save, in the CCP MSC Editor Menu Bar click File, then Save.
TIP - If Saving a Project for the first time, a main Folder titled 'Universal Remote
Control' should have already been created in My Documents while configuring the
remote and IR commands. It is highly recommended that specific folders be created
for Device Files and Project Files as a method for easily being able to save and locate
important system and programming data.
Downloading a CCP MSC-400 Project
1 Using the included USB cable, connect a USB port on the PC to the USB 1 front port on the MSC-
400 Front Panel
2 In the CCP MSC Editor Menu Bar, click Program, then click Download OR click Communications
and Send to Remote.
3 The Download window will appear. Highlight the MSC-400 then click Download to begin the
process. To cancel Download click on Close.
4 When successfully downloaded, the CCP MSC window will appear with the message: The
Download was successful.
5 Click Ok. The MSC-400 is ready for action.
Saving and Downloading Type in Section Title
55
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R