3Installing The Heater Pcb - Canon iR2020 Series Installation Procedure

F-1-59
5) Remove the two screws [1], and then the delivery
tray [2].
When removing or reinstalling the delivery tray, be
careful not to damage the paper holder [3].
F-1-60
6) Using a nipper or the like, cut out the face plate [2]
(used to install a heater switch) on the lower-right
cover [1].
F-1-61
1.5.3 Installing the Heater
PCB
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Install the heater PCB unit [2] using the two sup-
plied TP screws (M3x8) [1].
2) Install the heater switch [3] on the right side panel.
Install the heater switch with the OFF position on the
left and the ON position on the right just like the main
power switch.
Chapter 1
0011-3365
25