Placing The Bobbin Case And The Bobbin - JUKI LZ-2290CS Instruction Manual

3-3. Placing the bobbin case and the bobbin

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❶
B
There may be a case where several stitches at the start of sewing are difficult to be knotted
when thread trimmer is used with thin filament thread such as (#50, #60 or #80) using hole B.
At this time, use the other hole or perform the sewing starting from the right.
③
②
①
A
– 21 –
1) Turn the handwheel by hand to raise the needle
to its highest position.
2) Take a bobbin by your right hand with the thread
drawn out about 5 cm from the thread end of the
bobbin and place it into the bobbin case as illus-
trated.
3) Thread the bobbin case in the order of the num-
bers and pull it out through the thread path as
illustrated. The bobbin rotates in the bobbin case
in the direction shown by arrow when bobbin
thread is drawn.
4) Raise bobbin case latch ❶ and hold it between
your two fingers as shown in the figure on the
left.
5) Insert the bobbin case into the sewing hook shaft
as far as it will go by putting your hand from the
under cover of the inner hook. (Click sounds.)
6) Release the bobbin case latch to let it steadily
rest in the closing position.
How to use the bobbin case thread hole
1) Use hole A mainly for zigzag stitches other than
2-step zigzag stitch and scallop zigzag stitch.
2) Use hole B mainly for 2-step zigzag stitch and
scallop zigzag stitch.