Removing The Needle Bar Stopper; Attaching The Knee-Lifter; Adjusting The Height Of The Knee Lifter - JUKI LZ-2290CS Instruction Manual

2-4. Removing the needle bar stopper

❶

2-5. Attaching the knee-lifter

❶

2-6. Adjusting the height of the knee lifter

❶
❹
❸
❸
❷
❷
Remove needle bar stopper ❶ for transportation.
Keep the needle bar stopper which has
been removed, and install this nee-
dle bar stopper when transporting the
sewing machine. The needle bar stopper
may be cut when it is strongly drawn
out. Slightly move the needle bar to the
right or left and slowly draw out the nee-
dle bar stopper.
Insert knee-lifter into attaching hole ❷ and tighten it
with bolt ❸ .
Adjust the position of knee lifter pad ❶ to a con-
*
venient place. For the reference dimension, the
position is 220 mm from the bottom face of table.
1) The standard height of the presser foot lifted
using the knee lifter is 10 mm.
2) The lift of the presser foot can be adjusted with
knee lifter adjustment screw ❶ .
Do not operate the sewing machine in
the state that presser foot 3 is lifted by
10 mm or more since needle bar ❷ and
presser foot ❸ , or wiper ❹ and presser
foot ❸ come in contact with each other.
– 5 –