User Leds And Push-Buttons; On-Board Sensors; Hardware Documents; Lp V2.0 Reva- Pg 1.11 - Texas Instruments CC3200 User Manual

CC3200-LAUNCHXL User's Guide
J20 TDI In
1.1.5

User LEDs and push-buttons

There are 3 user LEDs on the board along with 2 push buttons. The usage can be controlled by the application program.
Signal mapping
Reference Colour GPIO maping
D7 GREEN GPIO_11
D6 YELLOW GPIO_10
D3 RED GPIO_09
SW1 NA GPIO_13
SW2 NA GPIO_22
1.1.6

On-board sensors

There are two sensors on the board which are connected to the I2C bus. The sensors can be isolated from the I2C bus
using the jumpers J14 and J13. By default the pull-ups on the I2C are not enabled. To enable these install jumpers J7 and
J8.
The sensors available on the board are listed below with their address
Reference Part No
U8 TMP006 Temperature sensor 0x41
U7 BMA222 3-Axis Accelerometer 0X18

Hardware documents

LP V2.0 RevA- PG 1.11

Schematics
Assembly diagram
Bill of materials
ECO List (Changes made to the sch/bom )
Gerber Files

Software Information

1.1.7

USB driver (For BP/LP)

For Windows (XP, Win7)
8
comment
Glows when GPIO = 1.
Glows when GPIO = 1.
Glows when GPIO = 1
High when pressed.
High when pressed.
Type Address
Schematics
Placement diagram
Bill of materials
pcb (Gerber) files
Link
CC3200-LAUNCHXL User's Guide