Table of Contents
Advertisement
Connecting a Component Video source device
Examine your Video source device to determine if it has a set of unused Component Video
output sockets available:
•
If so, you can continue with this procedure.
•
If not, you will need to reassess which method you can use to connect to the device.
To connect the projector to a Component Video source device:
1.
Take the (optional accessory) Component Video to VGA (D-Sub) adaptor cable and
connect the end with 3 RCA type connectors to the Component Video output sockets
of the Video source device. Match the color of the plugs to the color of the sockets;
green to green, blue to blue; and red to red.
2.
Connect the other end of the Component Video to VGA (D-Sub) adaptor cable (with
a D-Sub type connector) to the D-SUB/COMP IN socket on the projector.
3.
If you wish to make use of the projector (mixed mono) speaker, take a suitable audio
cable and connect one end of the cable to the audio output socket of the computer,
and the other end to the Audio socket of the projector.
The final connection path should be like that shown in the following diagram:
If you connect the projector to a High Definition TV (HDTV) tuner, the following standards
are supported:
•
480i
•
576i
•
720p (50/ 60 Hz)
•
The projector is only capable of playing mixed mono audio, even if a stereo audio input is
connected. See
•
Component Video is the only video output that delivers native 16:9 aspect ratio picture.
•
If the selected video image is not displayed after the projector is turned on and the correct
video source has been selected, check that the Video source device is turned on and
operating correctly. Also check that the signal cables have been connected correctly.
20
Connection
A/V device
Component Video to
VGA (D-Sub) adaptor
cable
"Connecting Audio" on page 19
Audio cables
•
480p
•
576p
•
1080i (50/ 60 Hz)
for details.
Advertisement
Table of Contents
