Controls and functions
Projector
1.
Power (Refer to
and
"Shutting down the projector" on
page 34
for more information.)
Turns the projector on or off.
2.
Blank/Q? (Refer to
page 30
and
page 34
for more information.)
Used to hide the screen image. You can
press any key on the control panel to
bring the image back.
To start FAQ function, press and hold for
3 seconds.
3.
Mode (Refer to
on page 29
Sequentially selects a predefined picture
setting available for each input.
4.
Source (Refer to
on page 26
Sequentially selects the input signal RGB,
Component Video, S-Video or Video.
5.
Auto (Refer to
on page 27
Automatically determines the best
picture timings for the selected input.
8
Introduction
"Start up" on page 23
"Hiding the image" on
"Utilizing FAQ function" on
"Selecting a picture mode"
for more information.)
"Switching input signal"
for more information.)
"Auto-adjusting the image"
for more information.)
13
14
8
7
1
9
2
3
11
6.
Lamp indicator light (Refer to
"Indicators" on page 49
information.)
Indicates the status of the lamp. Lights up
or flashes when the lamp has developed a
problem.
7.
Temperature warning light (Refer to
"Indicators" on page 49
information.)
Flashes red if the projector's temperature
becomes too high.
8.
Power indicator light (Refer to
"Indicators" on page 49
information.)
Lights up or flashes when the projector is
under operation.
3 Left
9.
Right 4(Refer to
10.
on page 27
for more information.)
When the on-screen menu is not
activated, #9 and #10 function as
Keystone -/+ hot keys.
6Menu (Refer to
11.
page 36
for more information.)
Turns on the on-screen display control
menu.
6
12
5
10
4
for more
for more
for more
"Correcting keystone"
"Using the menus" on