Samsung DigiMax V4 Instructions Manual page 25

Starting Herecording mode
Recording a still image
1. Insert the batteries (p.26).
Insert the batteries taking note of the polarity (+ / -).
2. Insert the memory card (p.29).
3. Close the memory card cover.
4. Slide the power switch to turn on the camera.
5. Select the PROGRAM mode by rotating the mode dial.
6. Point the camera towards the subject and compose the image by using either the viewfinder or LCD
monitor.
7. Press the shutter button to capture an image.
NOTICE
Blinking the autofocus indicator lamp means that the camera cannot focus on the subject.
Should this be the case, the camera cannot make beautiful photography.
INFORMATION
There are two LED lamps (one green, one red) positioned next to the viewfinder.
- If the camera is in focus when you press the shutter button halfway, the green LED will light
up and you can take an image. If the camera can focus on the subject, the autofocus frame
in the center of the LCD monitor will change from white to green.
- If the red lamp lights up, the flash can fire.
- If the red lamp blinks, the flash is being charged.
- When an image is being stored onto the memory card, the green lamp blinks slowly.
When the image data has been stored, the green LED light will go out.After the green LED
light has gone out, you can resume taking images.
27
Program mode
161
[RROGRAM mode]