Electrolux WASL3E 200 User Manual page 23

Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills
with water and drain
immediately.
The washing results
are not satisfactory.
The internal lamp is
off.
After a steam pro-
gramme, garments
are partially wet.
After a steam pro-
gramme, garments
are not sufficiently
smooth.
The drum is empty
and the display
shows there is some
weight in .
The drum is full but
the display shows
0.0 kg.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
Possible cause
Leakages from the couplings
of the water hoses.
Leakages from the drain
pump.
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
You set a not correct tempera-
ture.
Too much laundry load.
The lamp is burned.
The appliance is not accurately
levelled.
A wrong STEAM programme
has been selected (e.g. Syn-
thetic instead of Cotton).
Excessive laundry load.
It is necessary to set a tare.
You loaded the laundry before
to activate the appliance.
Possible solution
Make sure that the couplings are tight.
Make sure that the drain pump filter is
tight.
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
To replace the lamp, contact the service
centre.
Check the levelling and adjust the appli-
ance by raising or lowering the feet.
Note the composition of the fabric.
Reduce the laundry load
Press button
ance and to activate it again.
Press button
ance . Empty the drum and obey to the
necessary steps. (Refer to 'Loading the
laundy')
If the display shows other alarm message,
contact the service centre.
electrolux 23
1
to deactivate the appli-
1
to deactivate the appli-