FUTABA Big SkyLeaf Instruction Manual page 18

10
Cowling
1
● Cut a lot in order
to air cool the
e n g i n e w i t h
Dremel.
11
Switch ・ Receiver ・ Battery
1
● Install Battery and Receiver with Hook-and-Loop Tape inside the fuselage.
● Make a rectangular hole that is a little larger than the
total stroke of the switch so that you can turn the
switch ON/OFF without binding.
18
● Cut the part that interferes with
the engine and silencer of the
cowling.
2
● Fit the Cowling from the front to the fuselage and
secure it with six M3 × 10 Hex screws and six M3
washers.
● M3 × 10 Hex
● M3 washer
Make the mounting plate of the
switch with a wood board and attach
it to the side.