Daikin FTXS-L Series Engineering Data page 75

Operation Manual
Care and Cleaning
CAUTION
Units
Indoor unit and remote controller
• Wipe them with a soft cloth when dirty.
Front panel
1.
Open the front panel.
• Hold the front panel by the panel tabs on the both
sides and open it.
2.
Remove the front panel.
• Slide the front panel to either the left or right and pulling it toward
you.
This will disconnect the front panel shaft on one side.
3.
Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, wipe it with dry soft cloth,
dry it up in the shade after washing.
4.
Attach the front panel.
• Align the front panel shaft on the left
and right of the front panel with the
slots, then push them all the way in.
• Close the front panel slowly. (Press
the panel at both sides and the
central area.)
CAUTION
•
Do not touch the aluminum fi ns of the indoor unit. If you touch those parts, this may cause an injury.
•
When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.
•
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•
For cleaning, do not use hot water above 104°F (40°C), benzine, gasoline, thinner, nor other volatile oils, polishing compound, scrubbing brushes,
nor other hand stuff.
•
After cleaning, make sure that the front panel is securely fi xed.
74
Before cleaning, be sure to stop the operation and turn the breaker off.
Front panel
shaft
Slot
2) Pull
Front panel shaft
1) Slide
2) Pull
Split Type Air Conditioners FTXS-L Series
EDUS041129
Panel tab
1) Slide