Cisco VG400 Software Configuration Manual page 21

Configuring Voice Ports
3. service
4. shutdown
5. preference
The port subcommand specifies what ports to configure for a specific group command. It has the following
formats:
port <voice port#> [ans | called | dest] <E164 address> [desc <description>]
port <voice port#> [desc <description>]
port <voice port#>
port <start voice port#>-<end port#> [ans | called | dest] <E164 address> <interval>
[desc <description>]
port <start voice port#>-<end port#> [ans | called | dest] <E164 address> [desc
<description>]
port <start voice port#>-<end port#> [desc <description>]
port <start voice port#>-<end port#>
port all [ans | called | dest] <E164 address> <interval> [desc <description>]
port all [ans | called | dest] <E164 address> [desc <description>]
port all [desc <description>]
port all
• The
• The ans is the abbreviation for
dial-peer voice <tag> pots
• The called is the abbreviation for
subcommand under
• The dest is the abbreviation for
dial-peer voice <tag> pots
• The
zero and the allowable value is from 1 to 100, inclusively.
• Multiple port commands are allowed and can be removed one by one with exact port specification or all
at once using
• No overlay port commands are allowed. As a result, no other port commands are allowed if port all is
configured.
is composed of
voice port#
answer-address
.
dial-peer voice <tag> pots
description
.
denotes the interval value of the E164 number for each adjacent port. The default is
<interval>
.
no port all
slot#/subunit#/port# or slot#/port#
, which has the same meaning as the subcommand under
, which has the same meaning as the
incoming called-number
.
, which has the same meaning as the subcommand under
Cisco VG400 Voice Gateway Software Configuration Guide
Cisco IOS Bulk Configuration
.
15