Removal And Installation; Generator-2.4L Engine - Chrysler Stratus RHD 1997 Interactive Electronic Service Manual

BATTERY NEGATIVE POST
8C - 10 CHARGING SYSTEM
DIAGNOSIS AND TESTING (Continued)
RETRIEVING DIAGNOSTIC TROUBLE CODES
To start this function, cycle the ignition switch ON-
OFF-ON-OFF-ON within 5 seconds. This will cause
any DTC stored in the PCM memory to be displayed.
The malfunction indicator (Check Engine) lamp will
display a DTC by flashing on and off. There is a
short pause between flashes and a longer pause
between digits. All DTC's displayed are two-digit
numbers, with a four-second pause between codes.
An example of a DTC is as follows:
(1) Lamp on for 2 seconds, then turns off.
(2) Lamp flashes 4 times pauses and then flashes
1 time.
(3) Lamp pauses for 4 seconds, flashes 4 times,
pauses, then flashes 7 times.
(4) The two DTC's are 41 and 47. Any number of
DTC's can be displayed, as long as they are in mem-
ory. The lamp will flash until all stored DTC's are
displayed, then it will flash a DTC 55 to indicate the
test is complete.
ERASING DIAGNOSTIC TROUBLE CODES
The DRB Scan Tool must be used to erase a DTC.

REMOVAL AND INSTALLATION

GENERATOR—2.4L ENGINE
REMOVAL
(1) Release hood latch and open hood.
(2) Disconnect battery negative cable (Fig. 5).
(3) Remove accessory drive belt, refer to Group 7,
Cooling System for proper procedures.
(4) Disconnect the push-in field wire connector
from back of generator (Fig. 6).
Fig. 5 Removal/Installation of Battery Cables
BATTERY INDICATOR TEST NEGATIVE CABLE FIELD WIRE PLUG ENGINE MOUNT B+ TERMINAL GENERATOR GENERATOR T-BOLT PIVOT
Fig. 6 Wire Connectors
(5) Remove nut holding B+ wire to terminal on
back of generator.
(6) Separate B+ wire from generator terminal.
(7) Remove nut holding top of generator to adjust-
able T-bolt (Fig. 7).
Fig. 7 Generator–2.4L Engine
(8) Remove bolt holding bottom generator pivot to
lower mount.
(9) Remove generator.
INSTALLATION
(1) Place generator in position on vehicle.
(2) Install bolt to hold bottom generator pivot to
lower mount.
(3) Install nut to hold top of generator to adjust-
able T-bolt.
(4) Place B+ wire in position on generator termi-
nal.
(5) Install nut to hold B+ wire to terminal on back
of generator.
(6) Connect the push-in field wire connector onto
back of generator.
JA