Presser Foot; Needle; How To Change The Needle; How To Check The Needle - Brother VX880 How To Use And Enjoy Manual

Presser Foot
A /
1
Y o u w i l l f i n d various kinds o f presser feet
f o r special use i n the extension table.
A c c o r d ~ n g t o your sewing needs, i t may be
necessary t o change presser f o o t .
T O C H A N G E T H E PRESSER F O O T
1. Raise needle t o its highest position.
2. R a ~ s e presser f o o t .
3. Loosen presser f o o t t h u m b screw and
remove presser f o o t .
4. Place grooved s ~ d e o f the new presser
f o o t agalnst the flat o f the presser bar.
5. T ~ g h t e n t h u m b screw.
I
Needle
HOW TO CHANGE THE NEEDLE
1. Raise needle t o its highest p o s i t ~ o n .
2. Loosen needle clamp screw and remove
o l d needle.
3.
Insert new needle u p i n t o needle clamp
hole as far as
~t
w i l l go against the needle
stop. Make sure the f l a t side o f t h e
needle faces toward the back and the
long groove t o w a r d you.
4. Tighten needle clamp screw securely.
HOW TO CHECK THE NEEDLE
1. The
sewing needle must always be
straight and sharp f o r smooth sewing.
I
0
--
0
-
1
2. T o check i f needle is bent, place flat side
o f needle d o w n as shown I n illustration
Ix-
at left.