Dual Rgb Input Card - Barco Argus X Terminal User Manual

3.2.9 Dual RGB Input Card

The D RGB RGB I C
UAL NPUT ARD
1280×1024@75Hz or one analog signal up to UXGA resolution or higher are digitized for further processing in 5Hz or one analog signal up to UXGA resolution or higher are digitized for further processing in
A .
RGUS
Standard
The synchronization modes Hsync+Vsync, Csync and Sync-on-Green are supported.
Connectors
The D RGB I C
UAL NPUT ARD
signal to the O B . If an UXGA signal is inserted it must be connected to RGB In 1, while RGB In 2 is not avail-
MNI US
able.
Order
Within a single D RGB I
UAL
order in that the input cards are inserted into one or more put cards are inserted into one or more O
and 3.2.16 Arrangement of expansion
Specifications
For detailed technical specifications of the D
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
provides the capability of displaying RGB monitor signals. Either two analog signals up to
has two VGA compatible 15-pin SubMinD connectors. Each is for connecting one RGB
RGB In 1
RGB In 2
C the numbering of the video channels is as shown in the figure above. The
NPUT ARD
cards.
RGB I
UAL
SubMinD connectors. Each is for connecting one RGB
B devices is given in section
MNI US
C please refer to section
NPUT ARD
________________________________________________________________________
3. Getting started
Figure 3-24
connector of D RGB I
UAL NPUT
3.2.15 Argus OmniBus
7.1 Technical data.
C
ARD
3-19