Dual Rgb Input Card - Barco TransForm A series User Manual

3. Getting started

3.2.10 Dual RGB Input Card

The D RGB I C provides the capability of displaying RGB monitor signals. One or two analog signals up
UAL NPUT ARD
to 1280×1024@75Hz are digitized for further processing in T F A. With the model it is further-
RANS ORM RGB-3293-0
more possible to combine the capabilities of both input channels to digitize one analog signal up to
2048×1536@65Hz.
Standard
The synchronization modes Hsync+Vsync, Csync and Sync-on-Green are supported.
Connectors
The D RGB I C has two VGA compatible 15-pin SubMinD connectors. Each is for connecting one RGB
UAL NPUT ARD
signal to T F A. If an UXGA signal is inserted it must be connected to RGB In 1, while RGB In 2 is not avail-
RANS ORM
able.
RGB In 1
RGB In 2
Figure 3-31
connector of D RGB I C
UAL NPUT ARD
Order
Within a single D RGB I C the numbering of the video channels is as shown in the figure above. For the
UAL NPUT ARD
order in that the input cards are inserted into T F A, please see section 3.2.7 Quad Analog Video Card.
RANS ORM
Specifications
For detailed technical specifications of the D RGB I C please refer to section 7.1 Technical data.
UAL NPUT ARD
_____________________________________________________
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006 3-25