Installation - Smeg Oven 9FBYON Instruction Manual

2. INSTALLATION

2.1 Electrical connection
Make sure that the voltage and capacity of the power supply line match
the specifications indicated on the identification plate positioned on oven
door frame. Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a plug and socket connection is being used make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could
cause overheating and burns.
If a fixed connection is being used, fit the power line with an omnipolar
circuit breaker with a contact opening gap equal to or greater than 3 mm,
in an easily accessible position close to the appliance.
For operation on 220-240V
pole cable of the H05RR-F or H05V2V2-F type
(cable with a cross-section of 3 x 1.5 mm
The end to be connected to the appliance
must be an earth wire (yellow-green) at least
20 mm longer.
The manufacturer declines all responsibility for damage to persons or
things caused by the non-observance of the above prescriptions or
deriving from tampering with any part of the appliance.
26
Instructions for the installer
∼
: use a three-
2
).