Table of Contents
Advertisement
Instructions for the Installer
2. INSTALLATION
2.1 Electrical connection
Check that the power supply voltage and size are as specified on the
nameplate on the oven door frame. This nameplate must never be
removed.
The appliance must be connected to earth in compliance with electrical
system safety regulations.
If a socket and plug connection is used, check that they are of the same
type. Do not use reducers, adapters or junctions since they may cause
overheating or burns.
If a permanent connection is used, the appliance's power supply line
must be fitted with an omnipolar breaking device with contact gap of at
least 3 mm, located in an easily accessible position close to the
appliance itself.
Operation at 220-240 V
H05RR-F or H05RN-F three-wire cable
(cable of 3 x 1.5 mm
The earth wire (yellow-green) must be at
least 20 mm longer than the other wires at
the end for connection to the appliance.
∼
use a type
2
).
31
Advertisement
Table of Contents
