Tools And Equipment - Cisco ASR-920-20SZ-M Hardware Installation Manual

Tools and Equipment

Table 4: Accessories Kit
Variant
ASR-920-20SZ-M
Tools and Equipment
You need the following tools and equipment to install and upgrade the device and its components:
• ESD-preventive cord and wrist strap
• Antistatic mat or antistatic foam
• Number 1 and Number 2 Phillips-head screwdrivers
• #12-24 pan-head screws to secure the device to the equipment rack.
• Cables for connecting to network ports (based on the configuration)
• Ethernet hub, switch, or PC with a network interface card for connecting to the Ethernet ports
• Console terminal that is configured for 9600 baud, 8 data bits, no parity, no flow control, and 1 stop bit.
• Console cable for connecting to the console port
• Ratcheting torque screwdriver with a Phillips head that exerts up to 30-pound force per square inch
• Crimping tool as specified by the ground lug manufacturer
• Wire-stripping tools for stripping both 6 and 14-AWG wires
• Tape measure and level
• Ratcheting torque screwdriver with a Phillips head that exerts up to 15 inch-pounds (1.69 newton meters)
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
24
Category
19 inches
23 inches
ETSI
Wall mount
Desktop
Cable bracket
Dip Tray
(0.02-kilograms force per square millimeter (kgf/mm2)) of pressure.
of torque for attaching the ground wire to the device.
PID Accessories
A920-RCKMT-19 Yes
A920-RCKMT-23-H Yes
A920-RCKMT-ETSI Yes
A920-RCKMT-19 Yes
NA No
A920-CBL-GUIDE Yes
A920-CBL-BRKT-E
(ETSI)
A920-DRIP-TRAY Yes
Prepare for Installation