Connect To Eia Console Port - Cisco ASR-920-20SZ-M Hardware Installation Manual

Connecting a Cable to the Input 10-Mhz or 1-PPS Interface
Connecting a Cable to the Input 10-Mhz or 1-PPS Interface
Procedure
Step 1 Connect one end of a shielded mini-coax cable to the GPS unit.
Step 2
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the RSP of the Cisco
ASR 920 Router.
Connecting a Cable to the Output 10-Mhz or 1-PPS Interface
Procedure
Step 1 Connect one end of a shielded mini-coax cable to the Slave unit.
Step 2
Connect the other end of the shielded mini-coax cable to the 10-Mhz or 1-PPS port on the RSP of the Cisco
ASR 920 Router.
Connecting a Cable to the ToD Interface
Procedure
Step 1 Connect one end of a straight-through Ethernet cable to the GPS unit.
Step 2
Connect the other end of the straight-through Ethernet cable to the ToD or 1-PPS port on the RSP of the Cisco
ASR 920 Router.
Note

Connect to EIA Console Port

Note The serial console cable kit is not included with the device; it must be ordered separately.
Procedure
Step 1
Connect the RJ-45 cable to the EIA Console port.
Step 2 Connect the DB-9 end of the console cable to the DB-9 end of the terminal.
Step 3
To communicate with the device, start a terminal emulator application, such as Microsoft Windows
Hyper-Terminal. Configure the software with the following parameters:
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
50
For instructions on how to configure clocking, see the Cisco ASR 920 Series Aggregation Services
Routers Configuration Guide.
Install the Router