Attach Cables To The Dc Power Supply - Cisco ASR-920-20SZ-M Hardware Installation Manual

Attach Cables to the DC Power Supply

Attach Cables to the DC Power Supply
Note When installing DC power supply, use 14 AWG, 90°C wires. Always ensure that the building's installation
for short-circuit (overcurrent) protection does not exceed 15A.
To attach the DC power supplies:
Procedure
Step 1 Open the DC power supply guard.
Step 2
Attach the DC supply wires in the designated screws. See the figure below.
Figure 23: Connecting the DC Power Supply Wires
Step 3 Close the DC power supply guard.
Cisco ASR-920-20SZ-M Aggregation Services Router Hardware Installation Guide
40
Install the Router