Check Valve Removal And Replacement - EdgeStar DWP62BL Service Manual

Check Valve Removal and Replacement

The check valve is a one way valve that prevents wastewater in the drain system from flowing back into
the pump.
Tools and Parts Needed:
- Phillips Screwdriver
- Needle nose pliers
Step 1: Remove Base Tray Cover

Refer to instructions to remove panel found in the "Drain Pump Removal and Replacement"
section of this document.
Step 2: Remove the hose clamp on the drain pump

Use a flat tip screwdriver to pry the clips securing the ends of the crimp clamp together.

Remove clamp and discard.
supplied) are required to complete the repair.
- Flat Tip Screwdriver
- Gear drive hose clamp (1)
The original crimp clamps are not reusable. Gear drive hose clamps (not
26