Power Switch; Door Switch; Dispenser; Water Inlet Valve - EdgeStar BIDW1801SS Service Manual

Power switch

The Power Switch is used to turn on / off the power to
the unit. When checking or replacing the Power Supply,
ensure that the 4 wire terminals are properly and
securely connected in order to avoid a power disruption
or short circuit.

Door switch

The latch and switch assembly are located on the door
assembly behind the control panel cover. The
dishwasher will be not operate until the door is closed,
the latch engages the door catch (holding the door firmly
against the seal).
Note: There are two terminals on the door switch which
make contact when the door is closed.

Dispenser

The dispenser automatically dispenses both the detergent and the rinse agent at the appropriate times
1
When activated for the second time in a cycle, the lever lifts
the connecting rod by the notch, lifting the rinse dispenser
plunger (1) and releasing the rinse agent. When
deactivated, the lever returns to its original starting position.
The magnetic sensor(2) is connected to rinse aid warning
light at control panel by wires. When the indicator lights up,
the rinse aid volume is low and you need to add rinse aid.
2
To replace the dispenser, follow the below procedures:
1. Remove the 6 screws that secure the dispenser in place
2. Disconnect the terminals and remove dispenser
3. Reinstall replacement part by reversing above steps

Water Inlet Valve

The flow of water is controlled by a rubber flow washer capable of maintaining a flow of 4±5% liters per
minute with incoming water pressure of 0.04~1MPa. If the water inlet valve needs to be replaced, please
follow the below procedures:
1. Disconnect power
2. Remove the top panel, rear panel ,left /right side panel, baseboard and bottom board
3. Disconnect the 2 terminals from the water inlet valve
4. Remove the 3 screws and pull the valve
5. Remove the clamp and inlet hose from the water valve
6. Replace the water inlet valve
7. Reverse the above procedure to install.
17