Alcatel-Lucent 9768 User Manual page 42

Installing an 9768 MRO B4
....................................................................................................................................................................................................................................
Installing the AC power cable
There are two possible options while installing the AC power cable - using a connector or
hardwire the power cord.
Perform the following steps if your using a connector:
...................................................................................................................................................................................................
To terminate the unterminated end of the AC power cable, ensure that the plug used is
1
suitable to the environment of use. For example, in an uncontrolled outdoor environment,
use a waterproof plug that supports the supply voltage (120-V AC, 208-V AC, or 240-V
AC).
The cable may be cut down to length if the provided length of 14.7 ft (4.5 m) is more than
required. The plug must be provided by the customer.
...................................................................................................................................................................................................
Do not connect the far end of the power cord to the AC receptacle outlet or any other
2
power source until it is ready to turn on the 9768 MRO B4.
E
N D O F
...................................................................................................................................................................................................
Hardwiring the power cord
Perform the following steps to hardwire the power cord:
...................................................................................................................................................................................................
The AC power cord is 14.7 ft (4.5 m) long. Locate the AC junction box within reach of
1
the AC power cord.
Ensure suitable drip loops can be maintained at, both, the 9768 MRO B4 and the junction
box.
...................................................................................................................................................................................................
Route the AC power from the source to the junction box per acceptable local codes.
2
...................................................................................................................................................................................................
Hardwire the power cord to the power source. If a local disconnect switch or circuit
3
breaker is desired, install one in the junction box.
E
N D O F
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
Alcatel-Lucent 9768 MRO
3MN-MRO-AWS-IMOP
Issue 1 February 2014
S T E P S
S T E P S
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
Procedure 3-1: Installing the 9768 MRO B4 onto a wall or
pole
3-19