Electrolux EWF1284EDW Service Manual page 13


Sensor no. 3: SPIN SPEED (configurable)
The spin speed is always associated with the second sensor, in
combination with the six LEDs located in the bottom left hand corner
of the display.
The initial spin speed displayed is that set for the chosen programme.
Touching the sensor you can reduce the spin speed, indicated by the LED near the silk-screen printed value
on the control panel coming on. Once the lowest speed has been reached you can, if you wish, select "No spin",
"Stop water in tub" lighting up the relative symbol
programme).
The next selection will be the highest speed available for the selected programme.
The speeds that can be combined with the six LEDs are shown in the following table.
Max spin speed
(rpm)
Intermediate
Intermediate
Intermediate
Intermediate
Last selection

Sensor no. 4-5-6-7 (configurable)
Each of the sensors located on the right hand side of the display can be
combined with a LED and are used to choose one of the following four
selected options:
 Delayed Start
 Extra-rinse
 Easy Iron
 Pre-wash
Depending on the option/choices, the programme duration time is
updated (via the three digits).

Sensor no. 8-9
These two sensors are positioned under the display and act as:
 Time manager
Allowing the end user to lengthen or shorten the washing cycle duration,
this adjustment should be done after setting the temperature value and
the spin speed.
 Sensor no. 10
This sensor has the START/PAUSE function, used to start up a washing
programme, after selecting the washing cycle and required options; it can
also pause a cycle that has already started: to allow you to change
selected option or open the door (if the temperature conditions or water
level allow for this).
The cycle re-starts if you touch the sensor again.
The Led combined with this sensor flashes slowly: in the selection phase,
during the pause and at the end of a cycle with water in the tub. It stays lit
when a cycle is running and turns off when the cycle has ended and the
door is unlocked.
While other sensors when touched immediately change from selected to de-selected, in the case of this sensor,
more time is needed to avoid unwanted cycle start ups or pauses.
Technical Support - MDM
, or "Night cycle" (if compatible with the selected
800 1,000
600 800
400 400
No No
speed speed
Rinse Rinse
hold hold
Night Night
Cycle Cycle
13/97
1,000 1,200 1,200÷1,400 1,200÷1,400
800 800
600 400
No
400
speed
No Rinse
speed hold
Rinse Night
hold Cycle
1,000 1,000
800 800
400 400
Rinse No
hold speed
Night Rinse
Cycle hold
599 76 11-68 Rev. 01