Electrolux EWF1284EDW Service Manual page 30

Selector
position
TC3
- Door safety interlock
5
- Third solenoid valve
TC4
TC3
- Door safety interlock
6 - Fourth solenoid valve
TC4
(hot water where featured)
TC3
- Door safety interlock
- Wash solenoid, if the water in
the tub is not enough to cover
the heating element
7
TC4 - Heating element
- Weight sensor (if there is one,
an extra litre of water is loaded)
- Recirculation pump
TC3
- Door safety interlock
- Wash solenoid, if the water in
the tub is not enough to cover
8
the heating element
TC4
- Motor (55 rpm clockwise,
55 rpm anti-clockwise,
250 rpm pulse)
TC3
- Door safety interlock
- Drain pump
9
TC4 - Motor up to 650 rpm then
at maximum spin speed (**)
10 -----
Technical Support - MDM
Components activated
-----
Working conditions
Door closed
Water level below
anti-flooding level
Maximum time 5 min.
Door closed
Water level below
anti-flooding level
Maximum time 5 min.
Door closed
Water level above
the heating element
Maximum time 10 min.
up to 90°C (*)
Door closed
Water level above
the heating element
Door closed
Water level lower
than anti-boiling level
for spinning.
-----
30/97
Function tested LCD display
Water level in
the tub is
Water fill to third
displayed (mm)
solenoid valve
compartment
Water fill to fourth
solenoid valve
Water level in
compartment
the tub is
displayed (mm)
Heating
Temperature in
Circulation
°C measured
using the NTC
probe
Check for leaks
from the tub
Drum speed
in rpm/10
Drain, calibration
of analogue
pressure switch
Drum speed
and spin
in rpm/10
-----
599 76 11-68 Rev. 01
-----