Table of Contents
Advertisement
End of the Vapor Clean cycle
5. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
6. Use an anti-scratch sponge with brass
filaments on tougher encrustations.
7. In case of grease residues use specific
oven cleaning products.
8. Remove the water left inside the oven.
9. For improved hygiene and to avoid food
being affected by any unpleasant
odours, we recommend that the oven is
dried using a fan-assisted function at
160°C for approximately 10 minutes.
It is recommended to use rubber
gloves during these operations.
For easier manual cleaning of the
parts difficult to reach, we
recommend removing the door.
58
Cleaning and maintenance
4.10 Pyrolysis: automatic oven
cleaning (on some models only)
Pyrolysis is an automatic high-
temperature cleaning procedure
which causes dirt to dissolve.
Thanks to this process, it is possible
to clean the inside of the oven very
easily.
Improper use
Risk of damage to surfaces
• Remove food residue and drips from
previous cooking from the inside of the
oven.
• Switch off the burners or electric hot
plates of the hob installed above the
oven.
Preliminary operations
Before starting the pyrolysis cycle:
• Clean the internal glass panel following
the usual cleaning instructions.
• For very stubborn encrustations spray an
oven cleaning product onto the glass
(read the warnings on the product);
leave for 60 minutes, then rinse and dry
the glass using kitchen roll or a microfibre
cloth.
• Completely remove all accessories from
inside the oven.
• Remove the racks/trays support frames.
• Close the door.
Advertisement
Table of Contents
