FD and DFD 150X Series models are intended for
installation in accordance with fire damper requirements
established by:
National Fire Protection Association
NFPA Standard 90A
BOCA
National Building Codes
ICBO
Uniform Building Codes
IBC
International Building Codes
SBCCI Standard Building Codes
CSFM California State Fire Marshal
Fire Damper Listing (#3225-0981:102)
New York City (BSA/MEA listing #260-91-M)
"UL CLASSIFIED (see complete marking on product)"
"UL CLASSIFIED to Canadian safety standards (see
complete marking on product)"
UL Standard 555 (Listing #R13317)
RECEIVING AND HANDLING
Upon receiving dampers, check for both obvious and hidden damage. If
damage is found, record all necessary information on the bill of lading and
file a claim with the final carrier. Check to be sure that all parts of the
shipment, including accessories, are accounted for.
Dampers must be kept dry and clean. Indoor storage and protection from
dirt, dust and the weather is highly recommended. Do not store at
temperatures in excess of 100°F.
SAFETY WARNING:
Improper installation, adjustment, alteration, service or maintenance
can cause property damage, injury or death. Read the installation,
operating, and maintenance instructions thoroughly before installing
or servicing this equipment.
This manual is the property of the owner, and is required for future
maintenance. Please leave it with the owner when the job is complete.
Greenheck warrants this equipment to be free from defects in material and
workmanship for a period of one year from the purchase date. Any units or
parts which prove to be defective during the warranty period will be
repaired or replaced at our option. Greenheck shall not be liable for
damages resulting from misapplication or misuse of its products.
Greenheck will not be responsible for any installation or removal costs.
Greenheck will not be responsible for any service work or backcharges
without prior written authorization.
INSTALLATION SUPPLEMENTS
Refer to the appropriate Greenheck installation supplements
for special requirements:
•
Support Mullions
•
Shaftwall Supplement
•
Drywall Supplement
•
Grille Installation Supplement
Note: Refer to Greenheck IOM, Part #461335, for CFSD
models to be installed in corridor ceiling applications.
WARRANTY
Installation, Operation and
Maintenance Instructions
FD & DFD 150X
for
Curtain Fire Dampers
Vertical or Horizontal Mount
Maximum
6 in.
Duct
Retaining Angles
(See Section 3)
Duct
On types R & CR factory
furnished duct collar
qualifies as breakaway
connection.
Duct
Figure 1: Type A, Type B, and Type C,
CO, CR, R damper installation
diagrams.
Part #453946
MODELS
1
1
⁄
Hour
2
1/4 in.
minimum total
clearance
Wall or Floor
Maximum
6 in.
Damper
Type A
Wall or Floor
Damper
Type B
Wall or Floor
Damper
Type C, CO, CR & R