Troubleshooting - Maytag MFS80 Installation Instructions Manual

Door Will Not Unlock
Possible Cause
A power outage
■
Solution
If a cycle has started:
Microprocessor version: The door cannot be opened.
■
If a cycle has ended:
Microprocessor version: Press the stop button and follow
■
the instructions in the Programming Manual – Electronic
Programmer.
In an emergency:
IMPORTANT:
Before opening the door, turn off the washer.
■
Do not open the door if the drum has not completely
■
stopped.
Do not open the door if "TOO HOT" is displayed.
■
Do not open the door if any part of the washer feels too
■
warm.
Do not open the door if there is water in the drum.
■

TROUBLESHOOTING

In an emergency (cont.):
Models MFS80, MFS100, and MFS125:
■
Models MFS180, MFS230, and MFS275:
■
Use a screwdriver (1) or piece of wire with a maximum
diameter of 0.21" (5.5 mm). Insert the screwdriver or wire
through the finger hole in the lock cover (2) and push with
normal pressure. The latch mechanism (3) will lift up and
release the lock. The lock will stay unlocked even after the
screwdriver or wire is removed. You can open the door if the
drum is not rotating or if the washer does not contain hot
water.
3
2
Top view
Unscrew the bolt in the lock cover. Insert a screwdriver
into the hole in the lock cover and push gently. The latch
mechanism will lift up and release the lock. The lock will stay
unlocked even after the screwdriver is removed. You can
open the door if the drum is not rotating or if the washer does
not contain hot water.
Lock Cover
1
23