Remove Shipping Brackets - Maytag MFS80 Installation Instructions Manual

Commercial washer

Hide thumbs

Table of Contents

Enlarged version

Electrical Connection

The power supply of the liquid soap pump system must be

connected to an external electrical source. Only qualified

technicians can make the electrical connection according to local

codes. Instructions for the correct connection can be found on

the wiring diagram located in a plastic bag inside the cabinet.

Do not connect the liquid soap pump system in the washer.

Electronic Controller with MC5 and Graphic Display

For electrical connection of supply control signals, a plastic box

is located on the rear of the washer (see illustration below,

position 1). There is also a terminal box with LED signalization

of activation of the respective pump (position 2).

A label for electrical connections is located on the back side

of the terminal box cover (see illustration below). Detailed

information on connecting signals can also be found on the

electric schematic of the washer. Signals for the supply pump

control are 24V AC. Maximum current for control circuits of

pumps must be limited to 10mA. Insert the cable for connection

of pump control signals through the plastic cable strain relief

(position 3). After connection of conductors to the respective

positions of the connector "P" (screw clamps), attach the cable

by tightening the cable strain relief and replace the cover on the

box. For details about liquid soap supply system programming,

see the programming manual.

Electrical connection label

Rear Panel