Fiat 500 ABARTH CABRIO 2018 User Manual page 41

• Each time the ignition is turned to ON/RUN or
MAR (ACC/ON/RUN), the ESC system will be
on, even if it was turned off previously.
• The ESC system will make buzzing or clicking
sounds when it is active. This is normal; the
sounds will stop when ESC becomes inactive.
• This light will come on when the vehicle is in an
ESC event.
— Electronic Stability Control (ESC)
Off Warning Light — If Equipped
This light indicates the Electronic Stability Control
(ESC) is off.
Each time the ignition is turned to ON/RUN or
ACC/ON/RUN, the ESC system will be on, even
if it was turned off previously.
— External Light Failure Indicator Light
— If Equipped
The External Light Failure Indicator will come on
when a failure to one of the following lights is
detected:
• Direction Indicators
• Backup Lights
• Parking Lights
• Daytime Running Lights
• License Plate Lights
The failure relating to these lights could be:
• One or more blown bulbs
• A blown protection fuse
• A break in the electrical connection
— Fuel Cutoff Warning Light — If
Equipped
This warning light will illuminate after an accident
has occurred, and the system has shut the fuel off.
— Fuel Cutoff Failure Light — If
Equipped
This light will illuminate if there is a fuel cutoff
failure. If this light illuminates, take it to an
authorized dealer and have them inspect it.
— Generic Warning Light
The Generic Warning Light will illuminate if any of
the following conditions occur: Oil Change Re-
quest, Engine Oil Pressure Sensor Failure, External
Light Failure, Fuel Cut-Off Not Available, Parking
Sensor Failure, DST System Failure.
— Hill Holder Failure Warning Light
This warning light will illuminate when the Hill
Holder System is not functioning properly and
service is required. Contact an authorized dealer.
— Low Fuel Warning Light
When the fuel level reaches approximately
1–1.3 gal (3–5 L) this light will turn on, and remain
on until fuel is added.
— Engine Check/Malfunction Indica-
tor Warning Light (MIL)
The Engine Check/Malfunction Indicator Light
(MIL) is a part of an Onboard Diagnostic System
called OBD II that monitors engine and automatic
transmission control systems. This warning light
will illuminate when the ignition is in the ON/
RUN position before engine start. If the bulb
does not come on when turning the ignition
switch from OFF to ON/RUN, have the condition
checked promptly.
Certain conditions, such as a loose or missing gas
cap, poor quality fuel, etc., may illuminate the light
after engine start.The vehicle should be serviced
39