Table of Contents
Advertisement
Programming Additional Key Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user' s authority to operate the equip-
ment.
VEHICLE SECURITY ALARM
The vehicle security alarm monitors the vehicle
doors for unauthorized entry and the ignition
switch for unauthorized operation. While the
vehicle security alarm is armed, interior switches
for door locks and liftgate release are disabled. If
something triggers the alarm, the vehicle security
alarm will provide the following audible and visible
signals: the horn will pulse, the park lamps and/or
turn signals will flash, and the vehicle security light
on the instrument panel will flash.
To Arm The System
1. Remove the key from the ignition switch and
get out of the vehicle.
2. Lock the door using either the Central Lock/
Unlock switch or the Remote Keyless Entry
key fob and close all doors.
3. The horn will sound and the vehicle security
light in the instrument cluster will switch on
for approximately three seconds. This shows
that the vehicle security alarm is about to arm.
During this period, if a door is opened, the
ignition switch is turned to ON/RUN, or the
power door locks are unlocked in any manner,
the vehicle security alarm will automatically
disarm.After approximately three seconds, the
vehicle security light will flash.This shows that
the vehicle security alarm is fully armed.
To Disarm The System
Push unlock on the key fob, or insert the key into
the ignition switch and turn the ignition switch to
the ON/RUN position.
DOORS
Power Door Locks
A power door lock switch is incorporated into
the driver door handle. Push or pull the handle to
lock or unlock the doors and liftgate. If the
driver' s door handle is pushed, a red lock indicator
will show on the driver' s door handle (indicating
locked). When the door is closed, the door will
lock.
11
Advertisement
Chapters
Table of Contents
