Table of Contents
Advertisement
NETWORK SETTINGS MENU
The syntax to define a new hot key is as follows:
< keycode > [+| - [_] < keycode >]*
For example: Ctrl-Ctrl-A-Enter
or Ctrl+A-*1-Enter
Multiple key codes can be concatenated with a + or a - sign. The + sign builds
key combinations; all keys will be pressed until a - sign or the end of the
combination is encountered. In this case, all pressed keys will be released in
reversed sequence. So the - sign builds single, separate key presses and
releases. The _ (underscore) inserts a pause of user-definable length; more
than one _ (underscore) may be concatenated. The duration of a single pause
is set in milliseconds, using the appropriate option on the KVM settings page.
See Hot Key Table for a list of key codes that can be used as hot keys.
If the settings are correct, the KVM port can be switched using the KVM
switching matrix on the RIPC's home page. The RIPC uses separate mouse
synchronization settings and video settings for each port.
Note: It is still possible to apply KVM key combinations through Remote Access for
switching KVM ports, however, in this case video and mouse synchronization settings
will be shared among the ports and may unintentionally be exchanged for one of
those ports.
Firmware
This section contains a summary of information about this RIPC and its current
firmware, and allows you to reset the RIPC. This information is made available
under the Maintenance Panel Menu.
Maintenance Panel Menu
36
Advertisement
Table of Contents
