Installing The Hid Usb Driver - Belkin F1DD102U, F1DD104U User Manual

STEP-BY-STEP INSTALLATION GUIDE

Installing the HID USB Driver

Note: On some computers, you must enable USB support on your system
BIOS. Please reference your computer manufacturer's manual or
motherboard manual to verify that USB support is enabled.
1. Connect the 9V, 1A power adapter to the KVM Switch.
2. Boot up the computer you wish to connect via USB as you would
normally with the USB keyboard, monitor, and USB mouse connected
directly to the computer.
3. After the operating system finishes loading, using a standard
USB A-to-B cable, insert the end with the B-type connector to any
KVM Switch CPU port. Insert the other end of the cable with the A-
type connector to an available port on your USB computer. Your
computer should recognize your KVM Switch and automatically install
the HID USB driver. Once the driver is installed, you can power down
your computer.
4. Repeat steps 1 through 3 for each additional USB computer you wish
to connect to the KVM Switch.
10