Console Usb Mouse Port - Belkin F1DN104K-3 User Manual

aPPendICes
SECTIONS
Table of Contents
aPPendIX b – secure KM Configuration
utility (KMC loader) software
Belkin's Secure KM Configuration Utility (KMC Loader) allows you to load
the configured .kmc file (created per the procedure defined in Appendix A
of this manual) into the Secure KM Switch.
noTe: Please refer to appendix a for instructions on installing the
belkinKMadminsetup .exe file (that installs the KMC Creator and
KMC loader programs) and create the .kmc files needed for the
following steps .
setting up the KM switch for loading the Configuration ( .kmc) file
The KM switch is configured through a cable connected from a PC
containing the KMC Loader to the KM USB mouse port. The connection
is done via a special USB programming cable that is supplied with each
product.
1. Disconnect the mouse from to the Console mouse port of the KM
switch.
2. Connect the USB programming cable from a PC USB port to the
console USB mouse port of the target KM Switch.
3. Put the KM switch in setup mode by typing on the connected keyboard
(CTrl, CTrl, f11, d, c). The KM Switch will click several times to
audibly indicate that it needs to be power-cycled.
Belkin Secure 4/8 port KM Switch User Manual
®
1 2
loading utility
Once the KM Switch is in setup mode and is connected to the PC:
Figure 1 – KM Loading Utility capture – before selecting a file
35
3 4
4. Run the loading utility (KMC Loader). Wait for five to ten seconds until
the KMC Loader window shows "KM Ready", as shown:
5 6
Version Number
Model Name
FW Version
Previously Loaded file name
Previously Loaded file Create Date
Previous Load Date
Communication Port
7