Avaya J100 Series Installing page 27

Parameter Name
WLAN_WPA2E_ANONYMOUS_I
DENTITY
WLAN_L2QUAD
WLAN_DSCPAUD
WLAN_L2QSIG
SET WLAN_DSCPSIG
December 2018
Default Value
N/A
6
46
3
34
Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Hardware setup
Description
WIFISTAT parameter is enabled
and WLAN_SECURITY is set as
wpa2e.
The name must be from one to 32
characters.
Note that the space character and
ASCII 0x20 are not supported.
Specifies the 802.1x anonymous
name of pre-configured Wi-Fi
network. This parameter is
applicable if WIFISTAT parameter
is enabled,
WLAN_WPA2E_EAP_METHOD
is set to PEAP and
WLAN_SECURITY is set as
wpa2e.
The name must be from one to 32
characters.
Note that the space character and
ASCII 0x20 are not supported.
Specifies the layer 2 priority value
for audio frames generated by the
telephone.
Valid value is from 0 to 7.
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for audio frames
generated by the telephone.
Valid value is from 0 to 63.
Specifies the layer 3
Differentiated Services (DiffServ)
Code Point for signaling frames
generated by the telephone.
Valid value is from 0 to 63.
27