Table of Contents
Advertisement
8.3.
Click on the DETAILS tab. In the pull-down menu "Print to the following port:", select the correct port this printer
is connected to on the Bitronics switch:
LPx1 – PA (auto switch) " Select this if the printer is connected to Port A of the Bitronics switch
LPx1 – PB (auto switch) " Select this if the printer is connected to Port B of the Bitronics switch
In the image below, the printer is connected to Port B of the Bitronics switch. Therefore, LPx1 – PB (auto switch) is
selected. When done, click OK.
8.4.
Click on SPOOL SETTINGS and click on "Start printing after last page is spooled".
8.5.
If NOT grayed out, click on "Disable bi-directional support for this printer". Otherwise, ignore.
8.6.
Click OK in the Spool Settings window, and OK again in the main properties window.
Page 10
Advertisement
Table of Contents
